Hello all, Again i am seeking info on someone who is using his FTM-300 with echolink as gateway or repeater. What is the proper cable needed ? I...
I've been messing around for months trying to get a portable Ft8 system going. Rig: Yaesu FT891 Soundcard: Signalink Computer ASUS L210M So I...
Hello. I just performed my MARS mod on my 10y+ old European FT-857d and now the RX range is limited to 144-146MHz and similar for other bands.......
Unboxing the new Yaesu FT5D and my first gut reactions to have it in my hands. Check it out.... [MEDIA]
Audio is MUCH better than the FT-3DR [MEDIA]
Title sort of says it all. I've been using an FT-100 for VHF contests as a rover. I operate both FT8 and SSB on it and everything has been great...
I've been collecting some hand held radios lately and enjoy the older radios from the 1980s and 1990s. [MEDIA]
Has anyone figured out how to tap into the circuitry of the Yaesu FTDX10 to grab RF output? I’d like to take this signal and pump it into the...
Hello everyone, Very new to Yaesu Fusion radios...that is another story...i have a couple of questions on the FTM-300. I am trying to write from...
Hello, I am currently operating a Yaesu FT-857D with the MH-59 remote mic. The default button mapping on the mic is that the two "channel"...
Today I welcome John Kruk from Yaesu onto the Livestream to talk about the new FTdx-10 and new things upcoming at Yaesu. [MEDIA]
I fear the Yaesu G1000-SDX rotator on the tower has seen its last days. About six months ago, it seized up (refused to rotate in either direction...
Hi all! I have a Yaesu FT-2000 transceiver. As you'd expect it has a CAT (serial port) interface. The CAT interface lets you control the built-in...
This is one of those little features that I didn't think about until someone asked me to make a video on it's use. It's got a lot of utility for...
I have had the FTM-100DR radio for at least a year only putting out a watt. I finally got around to putting a new RF Final in today. Up in till...
I’m not sure why I never noticed, but documentation I’ve seen on the FTM-300 indicates that full-duplex cross-band repeater mode is supported. Has...
Found a need for doing this some more. Back in 2004, Gordon West and I initiated “pre-programming” Yaesu FT-60R HTs for new hams while I was...
I recently acquired an old Yaesu FT-100 (not the 'D' model), and was looking for info on how I might be able to have it work with my Icom AH-4...
OK, here's the problem: The radio was working fine and I enabled the password. Used it a few times and the password screen came up ok when I...
Hello everyone, I recently acquired a free Yaesu FL2100Z amplifier that needed/needs some repairs from a fellow ham friend. He told me that one...
