AO-40 transponders to open for experimental operation

Discussion in 'Amateur Radio News' started by Guest, May 5, 2001.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: Subscribe
ad: Left-3
ad: L-MFJ
ad: Left-2
  1. Guest

    Guest Guest

    The AO-40 team has announced that experimental transponder operation
    will start on Saturday, May 5, at approximately 0800z. The
    announcement comes in the wake of successful initial transponder
    tests last weekend.




    ''We expect good conditions on Saturday morning over North and South
    America and Europe,'' said AMSAT-DL President Peter Guelzow, DB2OS,
    an AO-40 team leader. Guelzow said the 435 MHz and 1.2 GHz uplinks
    will be connected to the 2.4 GHz transmitter passband.



    It's estimated that AO-40 will be available on May 5 in the Western
    Hemisphere from 0800 until approximately 1400z. Stations should use
    only SSB and CW. Guelzow said it's expected the transponders will
    remain available over a period of approximately 10 days.



    The uplink frequencies are 435.550-435.800 MHz and 1269.250-1269.500
    MHz. The downlink passband is 2401.225-2401.475 MHz. The
    transponders are inverting, so a downward change in uplink frequency
    will result in an upward frequency shift in the downlink.



    Users are asked to avoid the ''middle'' 2.4 GHz telemetry beacon and
    give it a clearance of 5 kHz on either side. Guelzow said the
    transponder might be shut down if the beacon cannot be copied
    because of interference.



    He emphasized that the operation is experimental, the schedule
    subject to change, and the transponders could be shut down at any
    time without warning.



    AO-40 ground controllers also plan to test the problematic VHF and
    UHF transmitters again.
     
Thread Status:
Not open for further replies.

Share This Page