RMS Express setup for Icom IC-7410
Prior to a computer upgrade I had the RMS Express working with my Icom IC-7410. I have gone through a different install process than before. I used the AGW Express Interface to install the HW virtual serial port, AGW packet, and RMS Express. I haven't tried sending anything but when I attempt to change the channels from the Winmore Winlink session it does not change on the radio.
I have the Signalink USB inline between the computer and radio. IT works for FLDIGI.
As with other applications, I selected the IC-7600 radio. Icom address of 80 (there is no 0x80), USB. Radio control port is COM73 which was setup in the HW virtual com port, baud 19200, and enable RTS and DTR.
Thank you for your help.