Yupiteru 7100 Advice on accessing the AGC line

Discussion in 'Radio Circuits, Repair & Performance' started by G3OAD, Oct 19, 2011.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: Subscribe
ad: Left-2
ad: MessiPaoloni-1
  1. G3OAD

    G3OAD Ham Member QRZ Page

    I have been trying to use this 7100 scanning receiver to carry out wide spectrum level measurement of harmonics and antenna performance, but I need to access the analog AGC (if it exists) or to interface to the IF so I can pass it thru an RMS chip (eg Analog Devices). has anyone succeeded with this kind of kluge? I don't have a circuit diagram, or layout drawing. Trev
     
Thread Status:
Not open for further replies.

Share This Page