YK88SN-1 Working or Not

Discussion in 'Radio Circuits, Repair & Performance' started by HR2TBD, Sep 4, 2010.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: MessiPaoloni-1
ad: Left-2
ad: L-MFJ
ad: Subscribe
  1. HR2TBD

    HR2TBD Guest

    Hey Guys, I have a question for the very experienced hams
    I have a friend who just installed a YK88SN-1 on a Kenwood TS850
    What call my attention is that when you press the filter selector and goes to the right position where the filter is located (270) even if there is a strong signal
    You will not hear anything after depressing the filter selector to any other position then the radio star hearing again, could it be that the filter is bad ?

    Or is that is not compatible with this model of radio or it's extremely hi cut
    Filter ?

    I saw him installing the filter and he did as manual say in the right place
    and he moved the dip switch which corresponds to that filter location.

    Thanks to read .

    All the best to you guys

    HR2TBD
     
Thread Status:
Not open for further replies.

Share This Page

ad: portazero-1