WSJT-X 3 secord Tx hang time

Discussion in 'Working Different Modes' started by KD7WPQ, Jul 27, 2018.

ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: l-BCInc
ad: Left-2
ad: Left-3
ad: Subscribe
  1. KD7WPQ

    KD7WPQ Premium Subscriber QRZ Page

    Just received a DataLink and connected it to my 706MKIIG and when transmitting it'll hang for 3 seconds at the end of the transmit with no audio which is apparent by the drop in power consumption and drop in audio on the bar on the screen.
    I was using a RigBlaster nomic but wanted something that would allow me to separate my audio from the onboard sound card and set audio levels independently. The RigBlaster would key and un-key exactly when it was supposed to, this one seems to hang for 3 seconds at the end of the Tx.
    FLDigi and QSSTV doesn't seem to have the same issue.
     
  2. G0JUR

    G0JUR Ham Member QRZ Page

    Its seems normal in FT8. the tx ceases at 12 seconds and there is a delay at the start of the tx period
    actual rf produced for 11.5 seconds.
    Thats what I have observed here.
     
    KQ9J and W4NNF like this.
  3. KB1VP

    KB1VP XML Subscriber QRZ Page

    Did you find an answer or resolution to this issue? I have the same problem using a different interface, and radio.

    Don
     
  4. KQ9J

    KQ9J Premium Subscriber QRZ Page

    I go directly into the FTdx3000 from the computer. It has always done this and I have never considered it a problem. :)
     
  5. N5SMO

    N5SMO Premium Subscriber QRZ Page

    If you are using Data/Voice VOX for keying, shorten the VOX hold time as low as you can.
     

Share This Page

ad: vanity