Wiring for Magnetic loops.

Discussion in 'Antennas, Feedlines, Towers & Rotors' started by N1KWW, Jun 14, 2019.

ad: L-HROutlet
ad: l-rl
ad: Left-2
ad: MessiPaoloni-1
ad: L-MFJ
ad: K5AB-Elect-1
ad: Subscribe
  1. N1KWW

    N1KWW XML Subscriber QRZ Page

    Loop constructed, 2' 1/4" copper, 10' RG8 coax. One image showed center conductor connected to copper loop and braid connected to copper loop plus also connected to large loop. Any info appreciated.
     
  2. KA0HCP

    KA0HCP XML Subscriber QRZ Page

    What image? What design. How about a link or photo? Unfortunately we are poor as ESP! ;)
     
    NH7RO likes this.
  3. NH7RO

    NH7RO Ham Member QRZ Page

    Welcome to the Mind Readers & Advisors Forum :D We regularly provide miraculous solutions for all your antenna problems with only the slightest amount of initial information and offer the fastest turnaround times on the internet...
     
    AF9US, KA0HCP and AA5CT like this.
  4. N1KWW

    N1KWW XML Subscriber QRZ Page

  5. N3PM

    N3PM Ham Member QRZ Page

    And I thought you guys were telepathetic![/QUOTE]
    Subtle but good.
    Mike N3PM
     
  6. AA5CT

    AA5CT Ham Member QRZ Page

    And, note telepathic does not infer empathetic :) ...
     
    NH7RO likes this.
  7. AA7QQ

    AA7QQ Ham Member QRZ Page

    It can be connected many ways. That is a simple loop feed & DC grounding the outer loop.
    Of course, it all affects tuning.
    Any "Loop Calculator" is just a tool to get general specs.
    Modify from there.

    Ed
     
    NH7RO likes this.

Share This Page