Windows 10 and the SC-20 Cabel

Discussion in 'Computers, Hardware, and Operating Systems' started by KN4UPH, May 25, 2019.

ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: Subscribe
ad: Left-2
ad: abrind-2
ad: Left-3
  1. KN4UPH

    KN4UPH Ham Member QRZ Page

    I cannot get my new Yaesu FTM-100dr/de to communicate with my laptop running Windows 10. I’m using the supplied Yaesu program of ADMS 9. All I get is an error on my radio. And the program says Format error or timeout. The program won’t even read my SD card info I have backed up. I went and tried to buy RT systems, but they are sold out.
  2. KA9JLM

    KA9JLM Ham Member QRZ Page

    Did you install the SCU-20 driver ?

    What is the radios Main Firmware Version ?

    There are 2 different versions of ADMS-9, You need to use the one that matches your Firmware version.

    Good Luck.
  3. KN4UPH

    KN4UPH Ham Member QRZ Page

    Thank you. I’ll take a look. I have installed the driver. But I did not know on the two different versions of the program
  4. KA9JLM

    KA9JLM Ham Member QRZ Page

    Make sure the driver you are using is made for Win 10. The old driver only works on Win 8 or under.

    10 is not supported using the old Unsigned driver.

    Good Luck. Just a minor bump it the road. You can make things work. :)
  5. N3JPP

    N3JPP Ham Member QRZ Page

    having the thing going on here updated my ftm-100dr looking for some help radio getting error mgs. n3jpp john

Share This Page