VFO 60M coverage

Discussion in 'Software Defined Radio (SDR)' started by KG4W, Dec 4, 2018.

ad: L-HROutlet
ad: l-rl
ad: Subscribe
ad: Left-2
ad: Left-3
ad: L-MFJ
  1. KG4W

    KG4W Ham Member QRZ Page

    Are there any rigs available that come with vfo coverage (not channelized coverage) of the 60 meter band ?
    Looking for rigs that do not have to be modified, but rather have this capability straight from the factory.

  2. AA7QQ

    AA7QQ Ham Member QRZ Page

    Pretty much any SDR will do so. It's the Software that decides.

  3. WA7BBI

    WA7BBI Ham Member QRZ Page

    My TenTec OmniVII covers the band. 73, WA7BBI
  4. KQ0J

    KQ0J XML Subscriber QRZ Page

    Since you can only legally use the channels, why do you need / want a VFO ?
  5. ND6M

    ND6M Ham Member QRZ Page

    1. so you can receive anywhere.

    2. there is a strong possibility a part of that band will become not channelized in the near future.
  6. KY1K

    KY1K Ham Member QRZ Page

    My old icom only requires a single diode to be cut for 1-30mhz coverage. Yes it's a modification, but it's the only object on the board and can be done with a pair of snips reaching in through the air vent if you didn't want to open the radio.
  7. W1VT

    W1VT Ham Member QRZ Page

    The Elecraft K3/K3S should meet your needs.
  8. WB2UAQ

    WB2UAQ Ham Member QRZ Page

    Plus you would never get the stability needed to stay in the center of the channel and meet the strict occupied BW requirements for 60 M.
    I hope the band remains channelized. Things are bad enough with the immature behavior on the rest of the ham bands with adjacent channel interference.
  9. K6CLS

    K6CLS Ham Member QRZ Page

    The US would keep the 5 channels we have. The additional 15kHz is separate, continuously tuneable. And international. And low powered.
    WB2UAQ likes this.
  10. KG4DYN

    KG4DYN Ham Member QRZ Page

    My Yaesu FT -897D will VFO tune 60 meters.

Share This Page

ad: k1jek