ad: wmr-1

TM-V71A TX issue with Echolink

Discussion in 'Echolink/IRLP Tech Board' started by AD8CJ, Mar 27, 2017.

ad: L-HROutlet
ad: l-rl
ad: MessiPaoloni-1
ad: K5AB-Elect-1
ad: L-MFJ
ad: Subscribe
ad: Left-2
  1. AD8CJ

    AD8CJ Ham Member QRZ Page

    I have the TM-V71A with the Kenwood Echolink cables. It's "working" for the most part, but I have this strange issue where Echolink gets stuck "transmitting" out of the network side, but not on the RF side.

    A signal coming in from the RF side fixes it, but the next station that transmits in from the internet side will cause the TX image to stay on, and constant white noise to come in on IP connected devices. The white noise does NOT come in for RF users, and the radio is not transmitting.

    Settings are defined per this FAQ http://www.echolink.org/v71a.htm

    The only difference is I could not check the Invert Sense as it worked exactly the opposite (It would transmit when nobody was talking, and cut off when someone talked). With Invert Sense checked, the same phantom TX issue was still present.

    Anybody have any ideas?

    73,
    KE8EXY
     
  2. AD8CJ

    AD8CJ Ham Member QRZ Page

    I took a video of the issue, it should be here within a few minutes.


    -KE8EXY
     

Share This Page