ad: k1jek

Ten Tec Scout 555 alingment

Discussion in 'General Technical Questions and Answers' started by W4RAM, Aug 2, 2020.

ad: L-HROutlet
ad: l-rl
ad: abrind-2
ad: Left-3
ad: Left-2
ad: Subscribe
ad: L-MFJ
  1. W4RAM

    W4RAM Ham Member QRZ Page

    My Ten Tec Scout 555 is out o frequency, (signal generator transmit in 7.050, radio receive in 7.051).
    I am reading instructions for alignment, but I am not sure what I need to adjust: if L2 and L3, (Receiver Control Board) or L1 and L2 (I.F Audio S/A Board), also if I need adjust L1 ((I.F Audio S/A Board)), I will need remove the BFO.
    Thank you for any assistance or advice with this matter.

    Al
    W4RAM
     

Share This Page