ad: chuckmartin

Signet SDG 1032X for IF Bandpass Measurement?

Discussion in 'General Technical Questions and Answers' started by AB1ZK, Jan 15, 2022.

ad: L-HROutlet
ad: l-rl
ad: l-BCInc
ad: L-MFJ
ad: Left-3
ad: Left-2
ad: abrind-2
ad: L-Geochron
  1. AB1ZK

    AB1ZK Ham Member QRZ Page

    Group,

    Can a Signet SDG 1032X frequency generator be used to sweep and display IF filter performance on a scope (TEK 7000)? I would like to use the generator to check out the XTAL filter and IF performance on a SP-400X.

    I am having a problem finding where the sync to the scope trigger is on the generator.

    Marc
     
  2. VK2TIL

    VK2TIL Ham Member QRZ Page

    The manual for the SDG1000X (at page 69) describes the trigger output function; I only found a data sheet for the SDG1032X but it shows the same screen display on the fifth of its unnumbered pages.
     

    Attached Files:

  3. AB1ZK

    AB1ZK Ham Member QRZ Page

    VK2TIL

    Thanks for the information.

    73,
    Marc
     
  4. AB1ZK

    AB1ZK Ham Member QRZ Page

    Finished the IF alignment. The Signet worked very well.

    Marc
     

Share This Page