RIGblaster duo not passing audio to transmitter(s)

Discussion in 'General Technical Questions and Answers' started by WW1ME, Jul 8, 2018.

ad: L-HROutlet
ad: l-rl
ad: Subscribe
ad: K5AB-Elect-1
ad: L-MFJ
ad: Left-2
ad: MessiPaoloni-1
  1. WW1ME

    WW1ME Ham Member QRZ Page

    Last thread fizzled. Trying again.

    I picked up a RIGblaster duo interface here on QRZ earlier this year. When trying to use it for FT8, I discovered that audio is not getting from the PC to the transmitter audio input. Audio is getting to the RIGblaster box, however, and I can get faint, distorted audio to the transmitter, but the level is being controlled by the rx level control on the RIGblaster duo, not the xmit level control.

    I've tried different cables, audio settings, switch settings, etc, without success. West Mountain Radio shrugged; their only suggestion was to send the box to them for repair.

    Is the RIGblaster defective, and, if so, is the issue repairable? I hate that I may have spent money on a defective box.

    The PTT functions from the software (N1MM+).

    The RIGblaster duo works fine for CW and FSK.

    I'm at a loss here. Any ideas?

    Thanks!

    Rick, WW1ME
     

Share This Page