QSO Today with Andre Hansen, K6AH, on AREDN mesh networks

Discussion in 'Amateur Radio News' started by 4Z1UG, Feb 23, 2019.

ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: Left-3
ad: QSOToday-1
ad: Left-2
ad: abrind-2
ad: Subscribe
  1. 4Z1UG

    4Z1UG Platinum Subscriber Platinum Subscriber QRZ Page

    Andre Hansen, K6AH, and his team of open source developers have taken amateur radio mesh networking to a new level with AREDN, that allows commercial low cost WIFI routers and access points to be used to build out local and regional broadband networks in the amateur bands above 2 GHz. Andre and I discuss this technology and its possibilities for the amateur radio community in this QSO Today.

    Show Notes: http://www.qsotoday.com/podcasts/K6AH

    Podcast Link: http://traffic.libsyn.com/qsotoday/Episode_238_Andre_Hansen_K6AH_Final.mp3

    iTunes Store: http://goo.gl/CvLNmV

    Stitcher: http://goo.gl/uhf1XZ

    Picture - Andre is holding two low-cost WIFI transceivers from Mikrotik that can be used to build microwave links tens of miles in length.
    N5MTX and KK4HPY like this.
  2. NL7W

    NL7W Ham Member QRZ Page

    On SSB or CW? :D:cool:
  3. 4Z1UG

    4Z1UG Platinum Subscriber Platinum Subscriber QRZ Page

    Why not? You could install remotely controlled Software Defined Radio receivers around on the network? Especially if the QRN is so high at your QTH, that a remote receiver would be helpful. Maybe build an HF translator - in on 40 meters, out on 80 meters?

Share This Page