ad: M2Ant-1

Passing a bit of time...TNC interface for Yaesu 897

Discussion in 'Homebrew and Kit Projects' started by EI6GXB, Nov 6, 2008.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: Left-3
ad: L-Geochron
ad: L-MFJ
ad: l-BCInc
ad: Left-2
ad: abrind-2
  1. EI6GXB

    EI6GXB Ham Member QRZ Page

    hi,

    Got a bit bored waiting for labs to start this morning and built a little interface for my 897 since I've been hooked operating PSK in college.
    About 1hr start->finish using the RASCAL plans, basically just isolating either sides of the circuit to stop grounding issues etc. Wound the Tx isolation coil, about 30 turns of 22awg.
    Yet to try it, but the one built yesterday works on the college's pro3 no bother.
     
Thread Status:
Not open for further replies.

Share This Page