Loop

Discussion in 'Antennas, Feedlines, Towers & Rotors' started by 2W0CSS, Nov 4, 2009.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: L-Geochron
ad: Left-2
ad: MessiPaoloni-1
ad: abrind-2
ad: Left-3
ad: L-MFJ
ad: HRDLLC-2
  1. G3TXQ

    G3TXQ Ham Member QRZ Page

    Interesting! Modelling an 80m full-wave loop in EZNEC it shows a slightly lower feedpoint resistance on 40m compared to 80m. Could it be feedline impedance transformation putting you out of range of the Pi Network rather than the loop itself?

    Steve G3TXQ
     
  2. K8JD

    K8JD Ham Member QRZ Page

    An antenna wrapped around the house will also get interference from houshold appliances and electronic gadgets. Maybe to the point you will have any but the strongest Ham radio signals blocked out of your receiver..:eek:
    I had a 40M loop running partially over my house.
    The interrference from the household items was so bad I finally had to move it into the woods behind my house and run 250 ft of coax to it.
    Now I can hear the weakest QRP signals.
     
  3. KI6ZIF

    KI6ZIF Ham Member QRZ Page

    I have a 40m loop. Works good on 80, works fantastic on 40m though. :D
     
  4. R3BU

    R3BU Ham Member QRZ Page

    Most of the factory tuners will not catch that high impedance.To add extra coil+tuner, and that's it-fantastic tuner.
     
    Last edited: Nov 16, 2009
Thread Status:
Not open for further replies.

Share This Page