Lesson learned

Discussion in 'Ham Radio Discussions' started by KI4ZUQ, Nov 1, 2019.

ad: L-HROutlet
ad: l-rl
ad: Left-2
ad: Subscribe
ad: MessiPaoloni-1
ad: L-MFJ
ad: Left-3
  1. XZ2A

    XZ2A Ham Member QRZ Page

    Then it should work if you turn the circuit through 180 degrees..... or hold it and stand on your head :) I think you mean 'back to front'!
     
  2. N5AL

    N5AL Premium Subscriber QRZ Page

    I would have just built it backwards, while holding the soldering iron from the opposite end! :)
     
    Last edited: Nov 2, 2019
  3. W1VT

    W1VT Ham Member QRZ Page

    I built the receiver and got it to work, though I don't remember when I etched to the board. I assume I waited until after the feedback/correction was published.
     
  4. K0MB

    K0MB Ham Member QRZ Page

    The trick to the receiver was to mount the one IC to the bottom of the board. None of the resistors or disc capacitors mattered, and there were few, if any, electrolytics. Then I tried to order a 14mHz fundamental xtal for the xmtr, and one supplier was rude enough to holler at me that there was no such beast. Now to be honest, the AccuKeyer was a home run and I used it for years, and Lew MCoy's stuff was great(even if I can't spell his name!). His QRP antenna tuner/swr meter was as good as could be.
     
  5. W4ZD

    W4ZD Platinum Subscriber Platinum Subscriber QRZ Page

    Lew McCoy was one of the great ones. Loved his QST articles. :)
     

Share This Page

ad: KF7PMW-1