IF Tap Panadaptor Buffer/Amp for SDR's

Discussion in 'Ham Made Gear' started by KD2C, Jun 18, 2017.

ad: L-HROutlet
ad: l-rl
ad: Subscribe
  1. KD2C

    KD2C Ham Member QRZ Page

    This Hi-z IF Tap Panadaptor Buffer/Amp will allow you to tap the IF in just about any receiver or transceiver
    with no degradation to the receivers IF signal path. The boards small footprint allows for easy installation (1 x 1 5/8).

    Each board incorporates a low pass filter designed specifically for your rigs IF frequency. The output can be routed to a $20 SDR dongle for an inexpensive, accurate panadaptor.

    Each assembled board is made to order based on your specific rigs IF requirements.

    The assembled board ships with:

    15 in. – RG 178 Output Cable
    15 in. – Red & Black 26 AWG Power Connection Wires
    15 in. – 30 AWG IF Tap Wire.
    The cost is $25 per board.

    If interested you can contact me at kd2c@verizon.net.

    20170617_190709.jpg
     
    K4LIX likes this.
  2. KD2C

    KD2C Ham Member QRZ Page

    Forgot to mention shipping:
    $3 - US
    $5 International
     
  3. KC3APU

    KC3APU Ham Member QRZ Page

    Do you have a pic of an assembled board, thinking of one for my Icom IC-746 (non pro) to add a panadapter. On this radio just tapping the IF kills the receive.

    3's

    Greg
     
  4. KD2C

    KD2C Ham Member QRZ Page

    Attached is a pic of the 7oMHz board. This is the version used for the IC746
     

    Attached Files:

  5. W7UUU

    W7UUU QRZ Lifetime Member #133 Life Member Platinum Subscriber QRZ Page

    Hi there - did you see my email? Have not heard back but you're posting in the thread so maybe that's where you want a response....

    Dave
    W7UUU
     
  6. KD2C

    KD2C Ham Member QRZ Page

    Just replied to your email.
     
  7. KD2C

    KD2C Ham Member QRZ Page

    Thank you all for your overwhelming response! Please see the notice below:

    The cost is $25 per board plus shipping.

    A Connection Kit is available for $7, this includes:

    15 in. – RG 178 Output Cable
    15 in. – Red & Black 26 AWG Power Connection Wires
    7 in. – 30 AWG IF Tap Wire.
    1 – SMA, BNC or RCA Female Panel Connector (Please specify when ordering)
    1 – 2x2 Strip of Double Sided 3M Foam Tape

    Shipping: $3 for US $10 for Canada & Mexico $14 for All Other Countries

    Thanks again!

    Dave
    KD2C
     
  8. KD2C

    KD2C Ham Member QRZ Page

  9. KE4CQ

    KE4CQ Premium Subscriber QRZ Page

    Email sent. Would like one for my Orion II.
    Thanks,
    Kevin
     
  10. KE4CQ

    KE4CQ Premium Subscriber QRZ Page

    Installed and works great Dave! Thank you.
     

Share This Page