ad: w5yi

ID-880H and KPC-3+ For WinLink

Discussion in 'General Technical Questions and Answers' started by K0TCM, Aug 18, 2019.

ad: L-HROutlet
ad: l-rl
ad: Left-2
ad: Left-3
ad: Subscribe
ad: L-MFJ
ad: MessiPaoloni-1
ad: K5AB-Elect-1
  1. K0TCM

    K0TCM XML Subscriber QRZ Page

    I have an elementary question regarding the use of my 880H and a Kantronics KPC-3+. I have done quite a bit of reading, but I thought I would reach out for hopes of a blunt, to the point explanation. The KPC-3+ I purchased used. Has the DB25 to USB for my PC and a DB9 to 6pin din port which fits nicely into the packet port on the radio.

    I have to assume that there is nothing more I need to worry about? I am confusing myself because I have a IC-2300H which is connected to my TNC Pi (DB9 to RJ45 mic and speaker).
    I have been worried that perhaps, I need a similar DB9 to RJ45 (Mic) and speaker plug rather than the DB9 to 6pin din that accompanied the KPC.

    Any shedding of light I would appreciate it. Just wanting to ensure I use the correct cabling for my WinLink RMS project.

    Terry
    K0TCM
     

Share This Page