ad: Preppcomm-1

Icon ic 756 pro iii not powering on dead

Discussion in 'Radio Circuits, Repair & Performance' started by W3TSB, Feb 24, 2021.

ad: L-HROutlet
ad: l-rl
ad: Left-2
ad: abrind-2
ad: Left-3
ad: Subscribe
ad: L-MFJ
  1. KD0RCB

    KD0RCB Ham Member QRZ Page

    So does radio work now?
     
  2. W3TSB

    W3TSB Premium Subscriber QRZ Page

    Well can’t get noise out of it. Did factory reset and when turning it on meter on left is at 9 . Center. I hooked up to antenna and no static. No noise. Buttons make noise and it has the voice chip and volume works. Need to make sure I done have some think set wrong but after factory reset you would think it would make noise. I’ll see if it transmits later too. And make sure it’s switches antennas . Might be something stupid.
     
  3. W3TSB

    W3TSB Premium Subscriber QRZ Page

    Well I seemed to cause the issue. Lol. I left the dsp board out . I opened and installed. Than reset... good now
     
    WA9UAA likes this.
  4. W3TSB

    W3TSB Premium Subscriber QRZ Page

    I caused it ..lol I left out the dsp board. I installed and seems to be ok now.
     
    WA9UAA likes this.
  5. VE3TMT

    VE3TMT XML Subscriber QRZ Page

    Hope you gave yourself a palm slap to the forehead!
     

Share This Page