HW-2036A Rx tuning

Discussion in '"Boat Anchor" & Classic Equipment' started by WB9TEN, Aug 8, 2019.

ad: L-HROutlet
ad: l-rl
ad: MessiPaoloni-1
ad: K5AB-Elect-1
ad: L-MFJ
ad: Subscribe
ad: Left-2
ad: Left-3
  1. WB9TEN

    WB9TEN Ham Member QRZ Page

    I've been working through an HW-2036A. When I got to the part in the Rx tuning that uses the reference change for an input signal, I cannot get any indication on the meter although the Rx "quiets". I used a Ramsey RF probe and I know that there is no RF at the input to the second mixer. The meter does work correctly on the Tx modes. Any suggestions for troubleshooting. This board is a real pain to remove.

    Thanks
    DaveWB9TEN
     

Share This Page

ad: Schulman-1