Getting WispDDE radio information on same com port as rotator information

Discussion in 'Amateur Radio Software' started by KG4GUF, Mar 10, 2011.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: abrind-2
ad: Left-3
ad: Left-2
ad: L-MFJ
ad: Subscribe
  1. KG4GUF

    KG4GUF Ham Member QRZ Page

    I'm working on a homebrew az-el satellite tracking antenna system and have settled on using Orbitron sending its data through the WispDDE client. I can extract rotator information using the Easycomm I format just fine. However, I can't seem to extract radio uplink/downlink information on the same com port. In the Wisp configuration, you can select different COM ports for the radio or rotator. I have them both setup to outport to the same COM port, but on the receiving end, I only get AZ and EL data, no uplink or downlink data.
    Is there some configuration I'm just missing, unfortunately, the site I got Wisp from didn't have a manual with it.
    Thanks for any help,
    KG4GUF-Matt
     
Thread Status:
Not open for further replies.

Share This Page