ad: M2Ant-1

GE/Ericson/Ma-Com Analog Voter

Discussion in 'General Technical Questions and Answers' started by WB4TF, Aug 18, 2018.

ad: L-HROutlet
ad: l-rl
ad: Left-3
ad: Subscribe
ad: abrind-2
ad: L-MFJ
ad: Left-2
  1. WB4TF

    WB4TF Ham Member QRZ Page

    Anybody have any experience with the old GE Analog voters? We have one and are having an issue where the voter votes noisy signals. When all signal are full quieting, or at least 20 db Sinad all is good. Voter votes perfectly. A couple receive site get a little noisy and the voter prefers the noisey signal over the full quiet one. We have five receivers with four using 440 to link back to the voter site...... All levels are equal from the receiver sites........ wireline from receivers set at -10dB with 1950 Hz status tone at -20 dB. Again, 20 dB sinad signals vote perfect. below 12 dB sinad and the voter seems to prefer the noisy signal....

Share This Page