ad: Schulman-1

Flex 1500 SDR TX delay setting. Where is it please?

Discussion in 'Software Defined Radio (SDR)' started by 2E0ILY, Aug 27, 2020.

ad: L-HROutlet
ad: l-rl
ad: Subscribe
ad: Left-2
ad: Left-3
ad: abrind-2
ad: L-MFJ
  1. 2E0ILY

    2E0ILY Ham Member QRZ Page

    I am getting a Flex 1500 SDR to play with alongside my Softrock RX/TX Ensembles. In the
    PowerSDR KE9NS v2.8.0 software run without VAC in use, how do I set a TX delay to run it into a linear amp please? Thanks.
     
  2. WD5ABC

    WD5ABC Ham Member QRZ Page

    Go to Setup, General, Options, TX Out delay is near the top. You'll need to check the box then set the delay in the box below it.

    73,
    Kerry , WD5ABC
     

Share This Page