Firmware for the antenna control controller

Discussion in 'Ham Made Gear' started by RZ1ZR, Jun 25, 2019.

ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: MessiPaoloni-1
ad: K5AB-Elect-1
ad: Subscribe
ad: Left-2
  1. RZ1ZR

    RZ1ZR Ham Member QRZ Page

    Firmware for the antenna control controller - price $57, touch screen 5.0 inches, Yeasu-type gearboxes, and self-made ones are supported, you can use a resistor, an encoder, a Hall sensor, or a magnetic sensor as the angle-of-turn sensor; the angle of rotation is roughly 10 degrees; screen by pressing the desired degree, or after 1 degree by turning and pressing the encoder. Orders for the manufacture of a finished controller are taken, the device size is 140x120x45 mm, power is 8-12 volts, ULN2004 output is open collector for switching antennas, two 250 volt 15 ampere relays for engine management, production time is about 3-4 weeks, depends on the time of receipt of components, the price of the finished device is $247.
     

    Attached Files:

Share This Page