ad: Radclub22-1

EZNEC WIRES TAB

Discussion in 'Antennas, Feedlines, Towers & Rotors' started by KD9DOG, Jun 6, 2021.

ad: L-HROutlet
ad: l-rl
ad: Left-3
ad: abrind-2
ad: HRDLLC-2
ad: L-Geochron
ad: Left-2
ad: L-MFJ
ad: MessiPaoloni-1
  1. KD9DOG

    KD9DOG Ham Member QRZ Page

    In the first segment of the program is straightaway and it tells me to set to set wire end 1, at X=0, Y=0, Z=30
    End 2 coordinates to be 0, 33.43, 30.
    Where does the 30 go as the last box after Z Conn I cannot enter anything into it Where do I put the 30
    HELP
     
  2. WA7ARK

    WA7ARK Ham Member QRZ Page

    If you only have one wire, then it connects to nothing else. That field is automatically filled in if you add a new wire where one of its end-points is within some small tolerance of a preexisting wire end-point. Read the Help file...

    upload_2021-6-6_9-7-3.png
    upload_2021-6-6_9-9-1.png
    upload_2021-6-6_9-12-31.png
     
    Last edited: Jun 6, 2021
  3. KD9DOG

    KD9DOG Ham Member QRZ Page

    I am just now learning and I am following the directions printed and where it gets to end 2 gets to , OK I see it, that is not a comma but a point had to put on the magnifiers to see.
     

Share This Page