ad: Amateur-1

Coil for vertical

Discussion in '3D Printing' started by PC1RZ, Aug 6, 2021.

ad: L-HROutlet
ad: l-rl
ad: Left-2
ad: MessiPaoloni-1
ad: L-Geochron
ad: abrind-2
ad: HRDLLC-2
ad: L-MFJ
ad: Left-3
  1. PC1RZ

    PC1RZ Premium Subscriber QRZ Page

    Well, new project started, making a coil for a shortened vertical.
    It is going to be used with a miliary 271 whip.
    Have to print te other cap. Hardware for connection, 3/8-24 bolts and nuts not on the picture.
    The coil can be found on thingyverse. (Not my design)

    [​IMG]
     
    N3VAN, KC2SIZ, KM5BOR and 4 others like this.
  2. PC1RZ

    PC1RZ Premium Subscriber QRZ Page

    And the finished coils
    Just before glueing the end cap on.(forgot to take picture after I glued them on )
    The wire is temporarily held in place with a big hoseclamp I normally use for my spiderbeam 12m pole.

    [​IMG]
     
    N6UH, N3VAN, KU3X and 2 others like this.
  3. N3VAN

    N3VAN Premium Subscriber QRZ Page

    Very nicely done. Please keep us posted on how well it performs for you! The 3D Printing is beautiful! What printer and filament did you use? Keep up the great work and thanks for sharing!
     
    N6UH likes this.

Share This Page