Choke location

Discussion in 'Antennas, Feedlines, Towers & Rotors' started by W5EDF, Jun 13, 2019.

ad: L-HROutlet
ad: l-rl
ad: abrind-2
ad: Subscribe
ad: L-MFJ
ad: Left-3
ad: Left-2
  1. KP4SX

    KP4SX Premium Subscriber QRZ Page

    Roof mount. Flat concrete roof with rebar embedded. About 35 radials of various lengths lying on the surface.
     
  2. WA7ARK

    WA7ARK Ham Member QRZ Page

    In that case, put the choke anywhere between the 75 Ohm to 50 Ohm junction and where the 50 Ohm enters the building.
     
  3. AI3V

    AI3V Ham Member QRZ Page

    What issue are you trying to address by adding these parts, and what are you expecting them to do?

    Rege
     
  4. KP4SX

    KP4SX Premium Subscriber QRZ Page

    Tnx.
     
  5. AJ6O

    AJ6O Ham Member QRZ Page

    I have chokes at my transceiver feed point, at the feed point just before my coax switch box out in the field, and at every antenna feed point. I have seen at least 2 s unit decrease in the noise floor after adding the chokes.
     
    KU3X and WA7ARK like this.

Share This Page

ad: hrd-2