Antenna Hitch mount

Discussion in 'Ham Made Gear' started by N6NED, Aug 18, 2011.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: MessiPaoloni-1
ad: Left-2
ad: Subscribe
ad: K5AB-Elect-1
  1. W5BIB

    W5BIB Premium Subscriber QRZ Page

    duh... Now why didn't I think of that... gonna do it now. (we get old, we get slow!!)
     
  2. W5BIB

    W5BIB Premium Subscriber QRZ Page

    ... Checked out my R/V situation. From the end of the 2 inch receiver to the point it goes vertical, needs to be right at 12 inches. Which would make the total length going into the receiver about 15-16 inches. WoW. when parked, I could extend a mast up to 25ft or so for the center of my OCF dipole!!.. Wat cha think? Steve
     
  3. N6NED

    N6NED Ham Member QRZ Page

    The measurment that I would like to have is from pin hole to where the mast plate would clear the tire by a few inches. That way I know exactly where I need to drill your hole. Ive noticed that not all recievers holes are in the exact same spot. Once again Steve, good idea about multiple holes!
     
  4. W5BIB

    W5BIB Premium Subscriber QRZ Page

    O.K., will get that info to you tomorrow. It's dark now & I'm afraid of things I can't see!!!:D:eek:
     
  5. W5BIB

    W5BIB Premium Subscriber QRZ Page

    ...from the center of pin hole out far enough to clear spare tire needs to be 12 inches.
     
  6. W5BIB

    W5BIB Premium Subscriber QRZ Page

    ...USPS money order en-route.:) Thanks, Steve
     
Thread Status:
Not open for further replies.

Share This Page