590sg vfo skips

Discussion in 'Amateur Radio Software' started by W8WJC, May 1, 2018.

ad: L-HROutlet
ad: l-rl
ad: l-assoc
ad: l-BCInc
ad: L-MFJ
ad: MessiPaoloni-1
ad: Subscribe
  1. W8WJC

    W8WJC Ham Member QRZ Page

    Hello everyone,

    Just curious if anyone has experienced the VFO skipping on a Kenwood 590sg while connected to a SDR? Here is my setup.

    Kenwood TS-590sg
    SDRplay RS1A
    iMac using CubicSDR

    When physically turning the VFO knob on the Kenwood TS-590sg, the VFO isn't smooth and skips. You notice this on the 590sg radio display. The knob/VFO is smooth and normal when disconnected from the SDR. This doesn't occur when connected to the computer through the COM port either, just seems like usb. I have the baud rate set at 57600.

    Any thoughts?
    Thanks,
    Will
    W8WJC
     

Share This Page

ad: ARR