I have a Dell e1505n that we purchased in 2007 when Dell released them with Linux installed. I have nursed this computer along fixing the display...
Hello, can someone make me a programming cable for a Yaesu 1900R, or tell me where the pins go. I want to got from a usb to rj-12/6 pin. Look...
Hello Folks. Hate asking for help on this. I got started with serial ports back when there was only a 1 byte buffer for in and 1 for out and...
Hey All! I'm having serious issues with USB noise using my Icom IC705. My entire 144 MHz and 70cm bands is covered with small spikes up to S5....
I'm too poor to buy cheap. :) I'm looking for recommendations for a USB sound card that really has a high SNR, minimal spurs etc. Not too...
I have a IC-7300 attached to my PC using the USB cable. The IC-7300 and PC are plugged into same outlet (so same ground path) All the USB cables...
Hello, I open this topic due to the fact that I had a problem with the IC 7300 when connecting to the USB port. Probably due to poor grounding,...
Short video going over the little vx 1r. Love this radio and its my favorite of the micro HTs because you can charge and run it off 5v usb. [MEDIA]
Anyone using 2 meter single side band? I'm running a local repeater crawl with one simplex stop and one participant suggested trying USB rather...
Hi QRZers; Ever found needing to have more than one app using the serial port - and you got bummed? Like, you doing some digital mode and...
Hello Everybody, I've been tinkering with my 991A to perform PY2RAF's panadapter mod and in so doing, I think I accidentally messed up the...
Hi Forum, In my quest abusing my FT-991A, I found that I can actually have two simultaneous CAT ports (already documented in this thread), with...
Dear all Can anybody give me a hand? I wanted to connect my ft991a via USB to a Win 10 laptop. On the Yaesu Website, I found the latest drivers....
I have a Yaesu 450D from time to time 50% of the time it will not transmit on usb or lsb . it will draw amps as if it is transmitting but there is...
I have been running FT-4 and FT-8. In the WSJT-x settings, the soundcard gave me the option of choosing USB Audio CODEC for the input and output....
What about you plugging your radio's USB port to the computer and obtaining the Audio, the CAT and... The digitalized spectrum I/Q SDR output to...
I just got one of these, and it has a quirk. Wondering if anybody else has seen this: If I power the OTUSB on with no GPS plugged into the gps...
Hi there, QRZers. In my quest abusing investigating my FT-991A functionalities, I found something very interesting. As of now, I thought that...
Hi Everyone! A few of you might have followed my 5-month odyssey on embedding a SDR in a FT-991A, without any extra wiring, drops, ports, drills,...
Hello there, QRZers. Resorting to the Community Knowledge. Scenario: FT-991A. Without a computer connected to it, just the radio and the...
