Help: wiring a turner+3 mic to a yaesu ft 225 rd

[IT9AHH]

hi all,can anyone help me?
How wiring a vintage 144 mhz all mode yaesu ft 225 rd to an amplified mic turner+3?
Thanks.
Franco it9ahh.

[KD8DEY]

mic needs to be set up inside for relay switching
pin 1 shield (Audio -)
pin 2 white (Audio +)

red & black wires to pins 1 & 3
Pin 4 not used

[KD8DEY]

Ps
If the mic is set up inside for electronic switching you may only need
pin 1 shield
pin 2 white
pin 3 black

[W9GB]

I have a vintage 144 MHz All-Mode Yaesu FT-225 RD that i want to use my Turner+3 amplified microphone.

You do not need the pre-amplifier built into this Turner microphone.

Set the audio pre-amplifier Gain Control (on Turner microphone) to a Minimal Level to avoid audio distortion.

[IT9AHH]

You do not need the pre-amplifier built into this Turner microphone.

Set the audio pre-amplifier Gain Control (on Turner microphone) to a Minimal Level to avoid audio distortion.

Thanks for your instructions.
Of course,i do not want to disturb anyone,and do not use linear amplifiers.
73's franco.