Hi All
I have one question about the Rigblaster Pro and the Yaesu FT-1000D. Here is my question

In the Rigblaster Pro manual on page 16 it shows the how to connect the CAT system to a
Yaesu rig It shows a 6 pin din plug and 1/8” plug and how to wire it for the CAT system. Now
the tip of the plug is the RXD, ring is the TXD and the ground is the ground. Is that showing the rear of the 6 pin din?

Also in the FT-1000d manual if I look at it right on page 7 it shows the pin out for the CAT plug.

Now here is what I would like to know. Pin #1 is the ground. I thing that I wire the plug from the Rigblaster like this. Pin #2 from the 6 pin din for the FT-1000D is the SERIAL OUT this will go to the tip RXD on the 1/8” plug to the Rigblaster. The ring on the 1/8” plug would go to the SERIAL OUT on the 6 pin din.

Can someone let me know if I am right?

73’s
Bob