Alinco EMS-14 desk mic wiring for Yaesu FT-450

[KC9PYV]

Like the title says, I'm looking to wire up an Alinco EMS-14 desk mic to my Ft-450. I already have the CAT-5 cable sitting here, and cut, but haven't a clue what wire goes with what. Is it possible to use this mic with this rig? The mic is powered off the rig. I don't care much if the up and down buttons work. I have the Alinco mic just sitting here collecting dust, and I'm tired of using the stock hand mic that came with the FT-450. I hope this is possible as I don't have the money to buy a new mic at this time. I always got good reports running that mic on my DX-70, and enjoyed using it. If anyone has any info on this combo, I would like to hear it. Thanks!

[KD8DEY]

http://myradio.piczo.com/microphonep...linkvar=000044


http://homepage.ntlworld.com/rg4wpw/date.html
HT-450
PIN1 FAST SCAN
PIN2 GROUND
PIN3 PTT
PIN4 MIC
PIN5 MIC GROUND
PIN6 + 5VOLT
PIN7 UP
PIN8 DOWN

[KD8DEY]

FT-450 EMS-14 Mic
PIN1 FAST SCAN
PIN2 GROUND Purple & Orange
PIN3 PTT RED
PIN4 MIC Yellow
PIN5 MIC GROUND Shield
PIN6 + 5VOLT Gray
PIN7 UP Green
PIN8 DOWN White

[W9GB]

I'm looking to wire up an Alinco EMS-14 desk mic to my Ft-450. I already have the CAT-5 cable sitting here, and cut, but haven't a clue what wire goes with what.

Category 5 cable is Unshielded Twisted Pair -- NO Shielding for audio line.
I have NEVER been an advocate or "fan" of this approach.

Too many years working in sound reinforcement and broadcast industry where "clean audio" was
the sound or broadcast engineer's "mission from God" (e.g. station owner, recording or performing artist).

w9gb