ad: dxeng

Yaesu 101ZD

Discussion in 'Ham Radio Gear For Sale' started by KK4JMH, Aug 9, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-assoc
ad: l-gcopper
ad: l-Waters
ad: L-rfparts
ad: L-Geochron
ad: l-innov
ad: l-rl
  1. KK4JMH

    KK4JMH Ham Member QRZ Page

    I have for sale a nice yaesu 101ZD that has been well taken care of. My brother gave it to me upon me getting my tech, but it is a bit much for me. I am wanting to sell it so I can buy a smaller and more portable rig. This rig works great me and my brother has made several contacts with this 101ZD and if you would like I would even throw in the pictured antenna tuner for an additional price. Also this 101ZD does have the 11meter crystals in place of the 10 meter ones.

    Price 101ZD $400.00 + S/H

    price 101ZD + MFJ antenna tuner $450.00 + S/H

    I will only ship to U.S. only



    Attached Files:

  2. KK4JMH

    KK4JMH Ham Member QRZ Page

    The price is negotiable or if you have anything to trade we can talk.
  3. N5ATM

    N5ATM XML Subscriber QRZ Page

    Do you still have the radio? Can you tell me what all comes with the radio? Also, can you tell me what condition the tubes are in and what power it is putting out? Thanks.

  4. KK4JMH

    KK4JMH Ham Member QRZ Page

    All of the tubes are in great condition. I have not had any problems with the tubes, The power output is 100w PEP on 20 - 160 meters. The radio comes with the radio, mic, and power cord. This rig has all of the options with it except the AM card.
  5. AC1S

    AC1S Ham Member QRZ Page

    PM sent. 73 - Tom AC1S
  6. N5ATM

    N5ATM XML Subscriber QRZ Page

    PM Sent

  7. WV3E

    WV3E XML Subscriber QRZ Page

    I know you're looking to sell, but the FT-101ZD is a fine, solid old boat anchor. If I was in your shoes and could swing a second portable rig, I'd consider keeping it.

    New radios these days are impossible to service yourself, this one is not. Parts are plentiful, especially the electrolytic caps which dry out with age and are the most common failure point. There's lots of useful information and user support available on Working on it will help you learn radio theory, and operating it will hone your skills, especially listening. It's got a sensitive receiver, but none of the fancy DSP or filters the new rigs have. Sometimes you have to work your contacts :) Get an external communications speaker like the SP-901 that's made for it, the audio is a 200% improvement over the internal one.

    There are lots of new hams that can't tune a set of tube finals and wind up smoking their first HF amp. The 6146B finals in your FT-101ZD aren'y indestructible, but they are very forgiving and relatively inexpensive. They also last a long time if they're not abused. On phone, keep the audio within the green on the ALC meter. If you ever run AM, keep the carrier under 25 watts. Avoid tuning up for more than 10 seconds at a time on a 25% duty ciycle (10 seconds on, 30 seconds off). Operating an old boat anchor like this takes patience, but can be very rewarding.

    The 10M crystal sets are available on Ebay fairly cheap. Like many old rigs (and some new ones) the ZD won't push full output on 10M, but there's little difference signal-wise between 70 watts and 100. Still more than plenty when 10M is open. When you upgrade to General you'll appreciate it even more, this rig really shines on 20-80M. Add a nice aftermarket microphone, and it excels for ragchewing. Tuning is a little cumbersome for contesting, but with an external VFO it's possible to operate split. Those pop up on eBay all the time.

    I hope you decide to keep the ZD. if you do I'm sure it'll serve you well, and if you don't, I'm sure it will do the same for your buyer. Please pack it carefully, it's an irreplaceable piece of amateur radio history.

    **Disclaimer - I'm not impartial, there's one sitting to my left as I type this, and although it's not my primary rig, I operate it at least once a week.**

  8. KK4JMH

    KK4JMH Ham Member QRZ Page

    Item sold on ebay
Thread Status:
Not open for further replies.

Share This Page