Want KNOB for project

Discussion in 'Ham Made Gear' started by W4EG, May 16, 2017.

ad: L-HROutlet
ad: l-rl
ad: L-rfparts
ad: Subscribe
  1. W4EG

    W4EG XML Subscriber QRZ Page

    I need a minimum 2 to 4 inch diameter knob.
    Shaft diameter is .6cm or in inches 4/16 = 1/4"
    Please state asking price.
    Thanks
     
  2. W4EG

    W4EG XML Subscriber QRZ Page

    Forgot to add my email address: w4egathotmaildotcom
     
  3. N2EY

    N2EY Ham Member QRZ Page

    What style of knob?
     
  4. N9PUP

    N9PUP Ham Member QRZ Page

    What material and Style.. Price would also depend on what size diameter and thickness you would want.

    Greg Prewitt
    n9pup
    PUP Machining LLC




     
  5. W4EG

    W4EG XML Subscriber QRZ Page

    The knob just needs to fit the description that I stated.
    1. Two to four inches diameter; so I can hold it and switch position.
    2. The diameter of the shaft is .6 cm or 1/4 inch so it can fit the shaft of the switch.
    This knob does not have to be brand new.
    Color does not matter and vintage neither. A photo will help me make the
    decision on whether I buy it or not.
    This knob switch is going outside of the house to change the length (inductance)
    of a coil: And only my back yard pest and pet are going to see it.
     
  6. W4EG

    W4EG XML Subscriber QRZ Page

    Here is a photo of a knob.

    Or anything you may have that resembles one of them.
     

    Attached Files:

  7. KF4ZGZ

    KF4ZGZ Ham Member QRZ Page

    [​IMG]

    (left to right)

    1- Na-Ald bakelite 2-1/8"knob 4" skirt 1/4" hole $13.00
    2- Daven Hi-Vis 1-7/8" 2-1/8" skirt 1/4" hole (has a chip-visible in pic) $10.00
    3- National 2-5/8" 3/8" hole - has room to drill out to 1/4" $13.00
    4- Not marked 1 7/8" knob 3-1/4" skirt, skirt is removable 1/4" hole $10.00

    All knobs use ( and have) set screws.
    prices included shipping

    Matt - I have a toolbox full of knobs email on here is good
     
  8. KA9JLM

    KA9JLM Ham Member QRZ Page

    How do you drill out a 3/8" hole to 1/4" ? :oops:
     
  9. KF4ZGZ

    KF4ZGZ Ham Member QRZ Page

    OOPS! 3/16" hole drillable to 1/4"

    All things seem possible when posting before coffee! lol :confused:o_O:rolleyes:

    Matt - Thanks for the correction
     
    KA9JLM likes this.
  10. W4EG

    W4EG XML Subscriber QRZ Page

    Matt,
    I do the same .... I am working on perfection! LOL
     

Share This Page

ad: KG5DTX-1