Vrc 321 heat transfer

Discussion in 'General Technical Questions and Answers' started by G4REK, May 4, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-assoc
ad: l-sarc
ad: l-Waters
ad: L-rfparts
ad: l-gcopper
ad: l-rl
ad: l-innov
ad: L-Geochron
  1. G4REK

    G4REK Ham Member QRZ Page

    Hi,
    Just done the LSB mod on my 321 radio, does anyone know how much to tighten the Hex heat transfer screws on the case...
    Finger tight ??? torque wrench tight ???? stripping thread tight ???? tighten up till thread strips then back it off a bit ????
    Jim g4rek
     
Thread Status:
Not open for further replies.

Share This Page

ad: elecraft