Rigexpert SD/Kenwood TS140 and N1MM setup issues

Discussion in 'Rig Control, Propagation, Cluster, & Other Softwar' started by K2RSB, Jan 21, 2011.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: Left-2
ad: MessiPaoloni-1
ad: Subscribe
ad: L-MFJ
ad: Left-3
  1. K2RSB

    K2RSB Ham Member QRZ Page

    I have a Rigexpert SD that works fine with my Kenwood TS-140 when I use the MixW software. No problems controlling the radio from the computer.

    I want to be able to use N1MM logger software with my Kenwood, but I can't seem to get the correct settings in N1MM to allow it to see the radio.

    I've done it in the past, but had some issues computer issues which caused me to re-install Windows.

    So here's the set-up:
    Windows XP
    N1MM Logger
    Kenwood TS-140S
    RigExpert SD

    I'm sure it's just a port configuration issue, but I'm lost on how to troubleshoot this. Any suggestions are welcome. Thank you in advance.

    Bob
     
Thread Status:
Not open for further replies.

Share This Page