Programming Software for a Kenwood TM261

Discussion in 'General Technical Questions and Answers' started by N4LPK, Aug 29, 2007.

Thread Status:
Not open for further replies.
  1. N4LPK

    N4LPK Ham Member

    Does anyone know if there is a source for programming software for a Kenwood TM 261? Kenwood doesn't have it on their site.  Also what cable is needed to program it?
     
  2. W6VPS

    W6VPS Ham Member

    Leslie:

    The Kenwood TM-261 is not designed to be programmed via computer. You must program it manually.

    73 Paul/W6VPS
     
  3. N4LPK

    N4LPK Ham Member

    Thanks Paul.
     I was thinking it may not have software available. I am not all that familiar with Kenwood models so I wasn't sure if it was or not. I can program it manually, I was just looking for a time saving solution to doing it that way. Thanks again.

    Les

    KI4GKD
     
Thread Status:
Not open for further replies.

Share This Page