Problems with FT-60R after using Commander software

Discussion in 'Amateur Radio Software' started by AD0AC, Apr 25, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: l-gcopper
ad: L-rfparts
ad: Subscribe
ad: K3QNTad-1
  1. AD0AC

    AD0AC Ham Member QRZ Page

    I used the Commander software to program memories into my FT-60. Now I would like to set band-edge scanning memories, but the radio will not let me select the memory spaces for doing so. It only goes from 000-999 now. Any ideas on what Commander did to my radio? I'd really hate to have to reset the radio and reprogram all of those memories by hand or shell out the $50 for the ADMS software.
  2. N1BHH

    N1BHH Ham Member QRZ Page

    You have to keep scrolling down past 999, they are there, labeled L1, U1, etc. After those you'll see the Home and VFO channels. I have a few of them set up but hardly ever use them, one of the few features I don't use.
Thread Status:
Not open for further replies.

Share This Page

ad: MyWorld-1