OHR 100A 40 Meter QRP Transceiver

Discussion in 'Ham Radio Gear For Sale' started by KF6YB, Aug 6, 2012.

Thread Status:
Not open for further replies.
  1. KF6YB

    KF6YB Ham Member

    This is a sweet and fun transceiver for QRP. The radio looks and operates very well. It was aligned by the factory for best operation. It features a built in K1EL paddle interface or you can use a straight key.



    I am asking 80.00$ for this great radio


    40M 7.000 - 7.070
    5W output on each band (4 to 4.5W on 15M), adjustable from a few mW to full
    power.

    [SIZE=+1] Single signal superhet receiver design.[/SIZE]
    [SIZE=+1] New ultra stable pre-mix VFO system providing high side
    L.O. injection.[/SIZE]
    [SIZE=+1] Local Oscillator signal is available at rear panel jack
    for use with the DD-1 digital dial.[/SIZE]
    [SIZE=+1] RIT with a range of ± 1KHz.[/SIZE]
    [SIZE=+1] Four pole crystal IF filter (we match the
    crystals).[/SIZE]
    [SIZE=+1] IF bandwidth front-panel adjustable from 1200Hz down to
    400Hz.[/SIZE]
    [SIZE=+1] True sine-wave side tone (not square wave or sampled RF),
    with adjustable pitch and volume.[/SIZE]
    [SIZE=+1] Silky smooth QSK.[/SIZE]
    [SIZE=+1] Precision 10K VFO tuning pot with frequency index on the
    front panel.[/SIZE]
    [SIZE=+1] Separate RF and AF gain controls provide for maximum
    comfort in noisy conditions.[/SIZE] OHR.jpg
     
  2. KD4ZRD

    KD4ZRD Ham Member

    How much to ship to 24089? Do you have manual? Thanks.
     
  3. K5CO

    K5CO Ham Member

    Oscar.......if the unit is still available, I'd like to buy it.
    Rob, K5CO contact at Hamcallk5co at aol.com or 505-898-6270
     
Thread Status:
Not open for further replies.

Share This Page