Kenwood D710 (or V71) and MCP-2A programming software import question

Discussion in 'General Technical Questions and Answers' started by NR8Q, Oct 6, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-assoc
ad: l-innov
ad: l-rl
ad: L-Geochron
ad: L-rfparts
ad: l-Waters
ad: l-gcopper
  1. NR8Q

    NR8Q Ham Member QRZ Page

    I have a D710 I'm trying to program. The D710 has been in service for a little while, so a lot of things about it are already configured in the menus, etc. I have used MCP-2A to read the configuration out of the radio and save it to a file. I have created a .hmk file that contains the necessary information to configure the Memory Channels for all the repeaters in Ohio. MCP-2A will import this file correctly. However, I cannot figure out how to merge the existing configuration I've downloaded from the radio with the Memory Channel data from the .hmk file. When I use File>Import>HMK, it erases all of the configuration settings (from the menus on the radio, etc) and the result is a radio that's in the factory reset state but with the Memory Channels programmed in.

    How do I keep the radio configured as it is now and just add the Memory Channels from the .hmk file to it?

    Ty (NR8Q)
Thread Status:
Not open for further replies.

Share This Page

ad: elecraft