<his:sent_exch> not populating.

Discussion in 'Ham Radio Deluxe - HRD' started by K5TCJ, Nov 10, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-gcopper
ad: l-rl
ad: l-innov
ad: L-rfparts
ad: l-Waters
  1. K5TCJ

    K5TCJ Premium Subscriber QRZ Page

    Created the following macro for sending a report and serial number.

    <his:callsign> <his:sent_rpt> <his:sent_exch> <his:callsign> TU GL<stop>

    I've got [xxx] in the sent exchange field in HRD Log. And it increments up each time I manually add a log entry.

    When I hover the mouse over this macro button to see what the macro would send, it looks good, except <his:sent_exch> is shown in bold and struckthrough.
    When I send that macro, all is good except that "his:sent_exch" is sent instead of the [xxx] number.

    Am I overlooking something or leaving something out, that the <his:sent_exch> command is not picking up the number from the logbook?


    Tim K5TCJ ​
Thread Status:
Not open for further replies.

Share This Page