Hand wired Fender Deluxe Reverb

Discussion in 'General Merchandise' started by N4RMT, May 3, 2012.

Thread Status:
Not open for further replies.
  1. N4RMT

    N4RMT Ham Member QRZ Page

    EDIT to add *CLONE*___This amplifier was hand built by yours truly about 2 years ago. It is a clone of the 1965 Fender Deluxe series of amps. (AB763 Circuit.) All resistors are new old stock carbon comp. Tone capacitors are all orange drop Spragues. Fiberboard circuit board, no PCB. All new JJ tubes. Added a bias adjustment pot and a jack to measure bias current of each output tube separately. Also has an added midrange pot on the rear. In a Ted Weber cabinet with a Weber signature series 12 inch speaker. Reverb / Vibrato footswitch included. This thing sounds amazing! I had a vinyl decal made for the front panel. *THIS IS A CLONE OF THE CIRCUIT AND DESIGN. IT WAS NOT MADE BY FENDER* If you play guitar much, or you're into tube amps then you know what this is. I can't ship this beast, so you can pick it up here, or I can meet you. You are welcome to try it out, but NO TIRE KICKERS. I'd like to trade for a NICE mobile rig in excellent condition with separation kit. TS480, FT857, IC7000 etc.
    [​IMG]
     
    Last edited: May 3, 2012
Thread Status:
Not open for further replies.

Share This Page

ad: 2ways-E