FT1000D relay RL1005 part wanted

Discussion in 'Radio Circuits, Repair & Performance' started by WK3A, Aug 17, 2018.

ad: L-HROutlet
ad: l-rl
ad: Subscribe
ad: Left-2
ad: Left-3
ad: L-MFJ
ad: MessiPaoloni-1
ad: l-assoc
  1. G3YRO

    G3YRO Ham Member QRZ Page

    Bottom line is that if you REALLY can't find a suitable similar relay that will solder straight onto the board (on ANY rig), then you could use almost any relay wired above the board with short leads !

    OR if you want to keep it neater - you drill small holes through the board to suit the pins of the new relay, and connect it with short bits of wire to the original pcb tracks underneath the board. (I did the latter on a piece of equipment recently)

    Roger G3YRO
     
  2. WK3A

    WK3A Ham Member QRZ Page

    Thanks all,
    The Mouser Elec source for the relay, OMRON G6E-134P was an exact match - fits perfectly.
    Been using it for a few days and the linear keying is working OK - time will tell if it holds up as well as the original of 24 years use....
     
  3. K1MMI

    K1MMI Ham Member QRZ Page

    Congrats on getting your FT1000D repaired with an OMRON relay.
     
  4. W9GB

    W9GB Ham Member QRZ Page

Share This Page