ad: NYQSL-1

Digipan setup problem using Windows 7?

Discussion in 'General Technical Questions and Answers' started by AA4MJ, Feb 4, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-assoc
ad: l-sarc
ad: L-rfparts
ad: l-gcopper
ad: L-Geochron
ad: l-Waters
ad: l-rl
ad: l-innov
  1. AA4MJ

    AA4MJ XML Subscriber QRZ Page

    I have a HP Notebook computer with Windows 7, I am trying to setup Digipan. When I came to STEP 10: Configure/Waterfall Drive, and I click on Waterfall Drive, I do not get the Recording Control Window. The same is true with the Transmitter Drive, I do not get the Master Volume Control window. What do I need to do to get Windows 7 show those two windows? My rig is Elecraft K3, with Elecraft Panadapter 3. Thanks, Bill AA4MJ
     
  2. KL7AJ

    KL7AJ Ham Member QRZ Page

    Open up yer winders volume controller to the "mixer" winder. See that all the right inputs are checked. It might be getting routed into oblivion.

    Eric
     
  3. G0GQK

    G0GQK Ham Member QRZ Page

    I had that problem with W7, in fact W7 was a pain because every time I changed bands the volume went down to zero and had to be reset, so getting mightily cheesed 'orf I went back to XP. In my humble opinion W7 was no improvement it was a pain in the harse.
     
Thread Status:
Not open for further replies.

Share This Page