Building the Ham Radio Workbench 12v Power Supply

Discussion in 'Amateur Radio News' started by K8MRD, May 27, 2019.

ad: L-HROutlet
ad: l-rl
ad: Subscribe
ad: Left-3
ad: L-MFJ
ad: MessiPaoloni-1
ad: Left-2
  1. K8MRD

    K8MRD Ham Member QRZ Page

  2. KC5HWB

    KC5HWB Ham Member QRZ Page

    FIRST TO REPLY, LOL
     
    KK6JKC likes this.
  3. KD8DEY

    KD8DEY Ham Member QRZ Page

    Does it come in Plaid?
     
  4. WB8LBZ

    WB8LBZ XML Subscriber QRZ Page

    Nice video. I think if you had a load on the circuit and you pulled the fuse, the red led should light. For KD8DEY, you can make it plaid but that is the next to the last step :) .

    73, Larry WB8LBZ
    El Paso, TX
     
  5. K4WDY

    K4WDY XML Subscriber QRZ Page

    Great video Mike. You da man! lol
     
  6. VE6XMB

    VE6XMB Premium Subscriber QRZ Page

    I think the red LED will light if the fuse blows, but the dead fuse will have to remain in the holder for this to light work.
     
  7. KC2JMS

    KC2JMS Ham Member QRZ Page

    I went to their web site and everything was out of stock... I hope your working on commission :)
     
    KD8DEY likes this.
  8. AG5TY

    AG5TY Ham Member QRZ Page

    Where to get kit? Contact info would be nice. Red Led will light when fuse blows with device pulling more than 20ma is connected.
    73 Good job!
     
    N5EAL likes this.
  9. K8MRD

    K8MRD Ham Member QRZ Page

  10. K8MRD

    K8MRD Ham Member QRZ Page

    Yeah they sold a lot at Hamvention. The should have some more in about a week or so.
     

Share This Page

ad: NADXA-1