ad: rfparts

AZ-EL system

Discussion in 'Antennas, Feedlines, Towers & Rotors' started by K8TDN, May 5, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: l-assoc
ad: L-rfparts
ad: Subscribe
ad: l-gcopper
  1. K8TDN

    K8TDN Ham Member QRZ Page

    I would like to know if I could take a Yaesu g-550 elevator rotor and a g-450 or any other AZ rotor and interface them into a single control box those for Yaesu g-5400 or 5600 and then into an interface; like the LVB Tracker; or similar. I am not familiar with the connectors on the Yaesu's rotors but I am thinking if I could piece together two Yaesu rotors they would plug into a single control box or I could use separate control boxes and interface them into the interface box. I could build AZ-EL system.


    73 Terry kc8ctc
  2. KB4QAA

    KB4QAA XML Subscriber QRZ Page

    Yes, you can build a control box. There are plans floating around the web.
Thread Status:
Not open for further replies.

Share This Page