Antenna coils

Discussion in 'Ham Radio Gear For Sale' started by K5WHR, Apr 19, 2012.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: L-rfparts
ad: l-gcopper
ad: Subscribe
ad: K3QNTad-1
  1. K5WHR

    K5WHR Ham Member QRZ Page

    Homemade loading coil no longer needed, was made for experimenting with
    loading a vertical antenna at the low HF bands. In the picture you will
    see the mounting hardware on the coil. This can be easily removed. It's
    hanger tape and some hardware. The coil is well made and supported with
    4 grommet strips where the wire was wound and fitted into the notches
    of the strips. Adhesive was used to hold the windings and strips together
    after the coil was formed.

    This coil can be used to load vertical antennas of various lengths across
    much of the HF spectrum but probably won't do well for 160M.

    Coil Dimensions:

    4.5" OD, 5.5" tall
    42 turns #12 copper
    ~ 100-108 uH


    I have 2 coils total, selling each for $36.00. Would like to sell both coils.
    If interested, let's work out a reasonable shipping and payment arrangement.

  2. WB4NAD

    WB4NAD Ham Member QRZ Page

    Nice job! I'm interested in only one.....
  3. QRZ
    Important Rules
    Have you read our Swapmeet Safety Rules?

    This forum enforces a set of buying/selling safety rules for the benefit of all users. Make sure that you're familiar with the rules before posting or replying in this area. Our moderators review every post in this forum and will flag or delete those that do not conform.

Thread Status:
Not open for further replies.

Share This Page

ad: hrd-2