Alignment Setting For A FT-7400

Discussion in 'Radio Circuits, Repair & Performance' started by KE6HEU, May 28, 2005.

Thread Status:
Not open for further replies.
ad: L-HROutlet
ad: l-rl
ad: L-MFJ
ad: K5AB-Elect-1
ad: MessiPaoloni-1
ad: Left-2
ad: Subscribe
  1. KE6HEU

    KE6HEU Ham Member QRZ Page

    Can anyone help? I am looking for re-alingment setting for an Yaesu FT-7400.
     
  2. WA2ZDY

    WA2ZDY Guest

    You need to align it to the specifications called for in the service manual. Proper procedures, test gear needed, etc, will all be found there. There is no "magic setting" for the internal adjustments.

    If you aren't sure you know what you're doing, the chance of screwing it up worse is about 110%. Go carefully.
     
  3. KE6HEU

    KE6HEU Ham Member QRZ Page

    Where can I find such information?
     
  4. WA2ZDY

    WA2ZDY Guest

    As I siad, it's in the service manual. I suggest you contact Vertex Standard about the availability. But the service manual will not teach how to do it.

    Again, tread carefully, you don't want to make things worse.
     
Thread Status:
Not open for further replies.

Share This Page

ad: elecraft